Engine

• warm air intake
• magnaflow exhaust(cat removed)
• short shifter(a.s.a.p)
• apc air breather
• ractive intake filter
• moto-master battery
• new 2.8 engine
• white wire covering
• blue wire covering
• taylor 8mm plug wires(blue)
• new clutch(may/23/07)
• new pressure plate(may/23/07)
• polished intake manifold
• polished valve cover(soon)
• painted intake manifold
• painted valve cover(soon)
• mr.gasket wire separators
• high pressure rad cap
• chip(not installed)(made by scott0999)
• ractive hose sleeving kit(not installed)
• .........
• comp cams timming chain/gears(soon)
• comp cams flat-tappet lifters(april)
• Moates emulator-ver.2(april)
• .................................
• Turbo parts:
• (so far i have)
• Garrett turbo t3/t4:
• a/r compressor: 0.42,a/r turbine: 1.00
• custom dump-pipe
• 2bar map sensor
• greddy type s bov
• greddy full-auto turbo timer
• Apexi AVCR boost controller
• Grand National Intercooler with stainless steel
• Gki fuel filter
• threaded iat
• compaq laptop to run Lm1 and tune the comp.

Exterior

• 8000k hid low-beam conversion
• 6000k hid high-beam conversion
• custom ballast holders/mounts(in progress)
• custom brackets for the holders/mounts(in progress)
• chrome clear corners
• custom badgless grill
• 5% tint
• phase 2 spoiler(from a 94)
• shaved badges and mouldings
• window decals
• body work(done summer of'07)
• new polar white paint(10/22/07)
• hood painted gloss black(10/22/07)
• polar white w/ black roof(this summer yaya)
• painted callipers blue
• color matched mirrors
• color matched bumpers and skirts
• shaved antenna(cut down)
• custom taillights(made by alpel)(april)
• custom 3rd led brake light(made by alpel)(april)
• bmw headlight swap(summer)

Interior

• blue seat belt covers
• alfa otto glow gauges
• apc pedals
• apc shift knob
• apc shift boot
• fold down backseat(from a 89)
• buckets with tilt(from a 94)
• trunk carpet(from a 92)
• blue neons in back-seat
• blue neons under dash
• blue neons under the seats
• painted interior pieces
• white panel vinyl in back
• custom pexi-glass switch panel
• custom upholstered front and back seats
• custom rear fiberglass deck panel
• power import s-wheel
• momo hub adaptor
• 2" sunpro tach w/ mount
• 2" powerfist boost/vacuum gauge(not installed)
• 2" faze air/fuel ratio gauge
• faze 2" blue bezals

Handling

• canuck lowering springs
• new tire rod end(old)
• new c/v joints(jan 5 07)
• new axles(jan 5th 07)
• 17" dai rims(1 rim brand new)
• 40 series antire rubber
• jasper brake pads(old)
• monroe shocks(old)
• phase-1 strut bar(painted/polished)
• rad to frame braces(painted)
• cowel to strut tower braces(painted)
• gm strut tower covers(painted)

Audio

• stinger wirring kit
• concept dash speakers
• 400watt kenwood 6x9s
• 2-12inch 1200watt kenwood subs
• kenwood excelon deck Kdc-x890
• 280watt kenwood tweeters
• tweeters mounted on side panels in front
• 2-kenwood crossovers
• 400watt kenwood amp
• 1800watt kenwood amp
• scosche 500watt capacitor
• non ported sub-box
• custom sub enclosure(not sure yet)
• power distribution block(with fuse)
• ground distribution block
• remote turn-on distribution block
• delphi nav 300 portable navagation

Future

• mrz lightweight alternator pully((not sure when)
• Idle relearn(cause of the chip)
• (A.goode)new headliner(possibly in vinyl)
• new carpet(unsure)
• (A.goode)custom door panels
• get the tranny rebuilt
• summit-racing light-weight flywheel
• spec stage 2+ clutch
• summit-racing 200amp alternator
• custom 2.5" downpipe.
• ported and polished heads,exhaust manifolds and upper and lower intake manifolds.
• mildly bored block
• forged pistons,crank and connecting rods
• 5-angle valve job
• summit-racing ls6 valve springs
• summit-racing comp cam camshaft
• summit-racing 24lbs injectors(might need different for turbo build)
• summit-racing crane gold roller rockers
• mrz underdrive pully
• mrz pollyurathane dogbone engine mount
• Urethane filled front engine mount
• Urethane filled upper tranny mount
• mrz polished billet egr delete plate
• 2.8 phenolic plenum spacers
• big bore 62mm t/b
• optima yellow top battery
• mrz strut brace(pay day)
• Turbo parts/build:(first pieces for engine build)
• tialsport 38mm wastegate.
• fuel pressure regulator
• oil line, oil return lines with all fittings
• universal 2.5" aluminum intercooler piping
• 5 bolt down pipe steel flange
• custom downpipe
• custom turbo exhaust manifolds
• summit battery relocation kit
• silicone couplings,and tclamps
• header wrap
• greddy oil catch tank
• Walbro Fuel Pump-high volumn and high pressure
• oil pan fittings for lines and gasket
• Lm1 wideband o2 sensor
• *some things are undecided*

Misc

• viper car alarm
• car-tarp for winter/summer
• car battery warmer(for winter)
• 3 socket c/lighter plug(relocated)
• ...
• Fluids:
• quaker state 10w30
• k&n oil filter
• prestone antifreeze/coolant
• motomaster washer
• motomaster tranny
• bardahl power steering
• valvoline DOT 3 brake
• dot 3 clutch
• ....
• Replacements:
• used engine mount
• p/s window crank
• upper gaskets and seals
• used washer lid
• new side posts
• used 1990 z24 rim&tire
• all new brake bulbs
• fuel pump relay
• drivers side window
• passenger side taillight
• next to new o2 sensor
• used 2.8 injectors(feb 2008)
• used vacuum lines(march 2008)
• new orings for all injectors(march 2008)
• used fuel rail/fpr(april 08)
• used 2.8 plenum(april 08)
• 4-lug nuts for 17s
• replaced alternator(april 08)

Comments