J-Body Automobiles Forum banner

2nd gen cup holder, how do you take off?

1406 Views 31 Replies 22 Participants Last post by  darkwheelman
I want to paint the outer part of my cup holder, how do i remove it?
1 - 20 of 32 Posts
The bar that drops down for the drinks to sit on comes out. Pull the cupholder out to open position, squeeze both sides of the bar and remove it. From there the cupholder should slide out in your hand.

As for the inner part that all slides into, I'm not sure how it comes out. When I took my cupholder out to fix it I didnt see any screws holding it, maybe it just presses into place like the speaker covers.
cupholder in a second gen????????????????????? where????????????????????????????????
migzz said:
rip it out!
lol, I was thinkin the same thing
Lol thats what i almost did!
dennisgt said:
cupholder in a second gen????????????????????? where????????????????????????????????
Phase 2 in the dash above the glove box :p

:pimp:
I hate that damn cup holder, anything I put in there falls on the floor.
When u pull the part that u slide it into out, u should see lil pins holding it in, Be careful when takin it out tho, u could break the pins and hafta put something in place of the cup holder becuase it wont stay in there nemore ;)
dennisgt said:
cupholder in a second gen?? where??
In the 2nd Generation, phase II, passenger side.

Adam
i had a hell of a time trying to get mine out, i finaly just said "the hell w/ it" and painted it in my car, *pix in registry* but i had to cover alot of stuff up w/ newspaper ;b

stupid cupholder...... mine works great though...
i want a cup holder in my car :( my 80 z24 don't got one :(
sask_cruiser said:
i want a cup holder in my car my 80 z24 don't got one
believe me you dont, it sucks so bad, if you find anything that will fit in the holes, it falls to the floor, the thing i use for cupholder is at the top of the console between the seats. lol
G
danlk2 said:
sask_cruiser said:
i want a cup holder in my car my 80 z24 don't got one
believe me you dont, it sucks so bad, if you find anything that will fit in the holes, it falls to the floor, the thing i use for cupholder is at the top of the console between the seats. lol
^^^^ so true, mine sticks half way out, and wont go back in, than i just beat the mother fucker till it goes in....... i also use the top of the console.... haha...
im with you guys, that thing sux so much, be glad if you dont have one
oops haha i can't spell... i meant 89 :)
mine works great, i dont know what problem you guys have
mine is stubborn sometimes, but with a little persuasion it usually decides to slide out. but i think it's got some old coffee spilled in the tracks. :-?
1 - 20 of 32 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top