J-Body Automobiles Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
638 Posts
Discussion Starter · #1 ·
Ok so I took the 3400 out of the vert and left the 5 speed Tranny bolted to the 3400. Now I installed the 5 speed Clutch pedal, brake, and clutch master cylinoid to the auto car. My next question is do I have to take and engine parts like kframe or anything to complete the swap? I know I have to install the 5 speed ECU, also the switch thingy that gets pushed in when I depress the clutch pedal. I also know I have to wire the switch. Is there anything I'm missing?
 

·
Registered
Joined
·
1,952 Posts
There is a how to. Dont press on the pedal with it disconected on the tranny end it will damage the hydrolics. The computer will learn the 5spd. You could always get a 5spd chip from a 5spd car of same Phase.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top