J-Body Automobiles Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
129 Posts
Discussion Starter · #1 ·
ive been reading about how to clear the side turning cells and umm.. it dont say nothing... that guy on the appearance board's page is overflowed with users for the last month and a half. Does anyone know how to clear those damn things. and if so plz dont give pages they seem to be down or non existant. Thx for any imput
 

·
Registered
Joined
·
129 Posts
Discussion Starter · #4 ·
Well after hunting for a little while and cursing the day i ever bought an 88' z24 i finally found the way to do it. here ya go fellas!

Custom Clear Corners

1. Remove your corner lenses with a Ratchet. (3 nuts on each)
2. Crack the plastic cover on the back around the lenses and remove it.
2. Take the shape of the orange lenses from mirror acrylic. (Home depot /5 bucks)
3. Now place it inside the corner light..
4. Then re-sealed the plastic backing. (all purpose tube sealant)
5. Put your corners back on.
 

·
Registered
Joined
·
129 Posts
Discussion Starter · #5 ·
after getting about 1/2 way to the end of the procedure a piece of plastic from my corner light desides to give tips for getting the corner light done.. use a small saw or knife to cut the two apart. its a pain the **** ass if you snap a small part of the cell.. oh well off to the recker for me... all the z'ds mourn my loss (DO NOT ATTEMPT THIS MOD IF YOU ARE A ROOKIE AT MODIFING GET A PERSON KNOWS HIS S***)
 
1 - 5 of 5 Posts
Top