J-Body Automobiles Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
202 Posts
Discussion Starter · #1 ·
I'm removing the engine from my 88 Z24 and i noticed that the crossover pipe does not unbolt to remove the engine to tranny bolts should it unbolt and it was welded? or do i have to remove the manifolds?? I got an engine out of a 90 buick regal (3.1L) and they unbolted with flanges.

maybe ill just unbolt the mainifolds and slide them away from the motor so i can reach the bolts.

any help is appreciated.
Thx
 

·
Registered
Joined
·
202 Posts
Discussion Starter · #2 ·
i found a coupler by the rear manifold (hidden under a heat sheild) but it was welded to the front mainifold so i had to take it off as well but the motors out!!!
 
1 - 2 of 2 Posts
Top