J-Body Automobiles Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter · #1 ·
does anyone have any good ideas for mounting the intak? If mine isnt slightly forced back and to the right it falls off. a picture and parts list would be helpfull if anyone has them.
 

·
Registered
Joined
·
364 Posts
What is the difference between using Moon's air intake design and a K&N drop in filter?

It seems to me you might get more power from the drop in because of the cowl induction, because I don't think Moon's system uses the induction, does it?
 

·
Registered
Joined
·
69 Posts
I bent the old airbox's mounting bracket all the way down, then used a hose clamp to hold the intake in place. I also have a peice of miscanalleous rubber wedged in between the end of the filter and the car's frame to push the whole assembly back. My intake is not exactly like moon's setup, however.

[ This Message was edited by: brantk on 2001-11-05 22:05 ]
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top