J-Body Automobiles Forum banner

Need a little help

254 Views 5 Replies 4 Participants Last post by  Brad91Z
I did the first custom wai from the how to, and i just taped the sensor to the top of the hose (on the outside), after driving for a bit the check engine light comes on, but isnt on when i first start or for about the first 10 minutes
could it be that the sensor is picking up the air on the outisde thinking that the "dirty" air is going into the motor? should i just relocate the sen=sor?
1 - 6 of 6 Posts
if you check the code then you will be able to figure out whats wrong
how? noone knows what it could be though?
check the code, then you'll get help. any suggestions would be a guess. check the how-to section for how to get error codes.
Yes, check the code first, that will pinpoint your problem.

Brad
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top