J-Body Automobiles Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4,528 Posts
Discussion Starter · #1 ·
well, i was drving along one day, and my car died. i have no power at the injectors. i replaced the crank sensor, ecm, icm, coilpacks. im getting 12 volts, to the ecm, at the wire that runs through the check engine light. but no where neaer the right amperage. the other 2 power wires running into the ecm have power and the right amperage. also, my ecm isnt giving any feedback, i cant get anything of my red brick snap on scanner, ecm wont talk back to it.. any ideas?

thanks!
sorry havent been on in a while, work, school and just all around not nough time to use the computer..
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top