I used a long bolt and big washers to basically press them in but it wouldn't go all the way Gets to that same spot and just stops. I know there suppose to be tight but this seems a bit ridiculous. I don't have a advanced auto near. O'Reilly might have a similar tool.
Rear axle bushings
Been rebuilding a rear axle and having issues getting new bushings installed.
I can get them most the way with a few hits with a deadblow but then they just stop. I know they aren't easy to get in and basically have to cut to get them out. I'm wondering if i should keep reaming the inside out to get them to fit or what? Or force them the rest of the way?
I took a few pics. Pretty obvious with a caliper that its too small.
I can get them most the way with a few hits with a deadblow but then they just stop. I know they aren't easy to get in and basically have to cut to get them out. I'm wondering if i should keep reaming the inside out to get them to fit or what? Or force them the rest of the way?
I took a few pics. Pretty obvious with a caliper that its too small.
Attachments
1 - 2 of 3 Posts
1 - 2 of 3 Posts
