J-Body Automobiles Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
11,294 Posts
Discussion Starter · #1 ·
I got the tranny side done tonight. I was using crappy grinding bits which basically all broke after awhile LOL

just enough to get one side done..

had a question.. did anyone try welding a washer in on the front side where the elongated hole is? I was wondering if a washer would hold up, seems like it would bent it.. unless if it was really thick
 

·
Registered
Joined
·
1,976 Posts
just use thick washers such as from unistrut.

i'm sure hardware stores have em around. ps i wouldnt use poly, just design a better rubber mount. if its TOO ridgid you'll just pull the mounting tabs or the rad support.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top