J-Body Automobiles Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
649 Posts
Discussion Starter · #1 ·
Not really a problem, more of a general question...I don't have my micrometer, so does anyone know the diameters of the front and rear sway bars on a 93 Z24 auto? Couldn't find anything by searching. TIA.
 

·
Registered
Joined
·
5,490 Posts
Front should be 30mm. Not sure about rear... Just take a string, wrap it around mark it, measure it, convert into mm (1cm = 10mm).. Then figure the diameter from the circumference (c=pi*d)
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top