J-Body Automobiles Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
467 Posts
Discussion Starter · #1 ·
Hey guys. I know this has probably been asked before, but I have searched and come up with nothing.
What exactly do I need to put a PH1 Z hood on my PH2 VL?

Any help is appreciated.

Sean
 

·
Super Moderator
Joined
·
20,044 Posts
A wrench and a 13mm socket, about 15 minutes and a buddy to help.

Just make sure it's from a same phase Z24 as your VL.
 

·
Registered
Joined
·
5,490 Posts
Doesnt matter if it's VL, RS, Z24, etc.. Just the phase like Six said... But if it's a 88-90 hood you want to put on a 91-94...

Remove the old latch on the p2 hood... Then measure measure measure and bolt it onto the p1 hood... I have pictures somewhere, I'll look for them

Found em... This is what it should look like after bolting the P2 latch to the P1 hood
 

Attachments

1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top